Applications: Can be used for any type-C source device, AC adapters, and power supplies for computer, consumer or portable consumer applications, and more.
On-Board Modules: USB-C Source Click is based on the STUSB4700, a standalone autonomous USB power delivery controller optimized as a provider to negotiate a given amount of power to be sourced to an inquiring consumer device from STMicroelectronics.
Key Features: Low power consumption, high-voltage capability, support full USB PD negotiation for Source applications, built-in over-voltage protection, and more.
Applications: Can be used for Portable and Infotainment Applications
On-Board Modules: Buck & Boost Click is based on the MIC7401, a powerful highly-integrated configurable power management (PMIC) featuring buck and boost regulators and a high-speed I2C interface with an internal EEPROM memory and micro-power shutdown function from Microchip.
Key Features: High-density five buck channels, one independent boost channel, 93% peak efficiency, fast transient response, short-to-ground fault detection, and more.
Fully compatible with Raspberry Pi models that have the 40-pin GPIO header (4, 3, 2, B+, A+, Zero)
Easy-to-use, simple setup, plug-and-play
QMI and PPP are supported
Clip-in Mini PCIe socket compatible with worldwide LTE, UMTS/HSPA+ and GSM/GPRS/EDGE coverage with regional or global modules which work with different frequencies & carriers
With the 4G/LTE Module(e.g Quectel EC25) you can reach 150Mbps downlink and 50Mbps uplink data rates. And the 3G Module( e.g Quectel UC20) delivers the maximum data rate of 14.4Mbps downlink and 5.76Mbps uplink.
Micro SIM Card socket can easily reachable on the upside of the HAT.
Can be used standalone with PC/Laptop over micro USB, without stacking with Raspberry Pi.
The HAT can be powered from an external 5V source by exposed power pins, directly from Raspberry Pi 5V GPIO headers, via micro USB, or optional JST connector on the bottom of the board. A specially designed 90-degree right angle micro USB cable is included to package.
Efficient and low quiescent current power circuit can hold up to 3Amps
Optional Send/Receive AT commands over Raspberry Pi UART port is available
Taking the module into the Airplane Mode, resetting module or RI and DTR functions can be accessible over GPIO pins.
The power of the whole board electronics can be disabled for low-power consumption use cases
The modules(EC25&UC20) have built-in GNSS(GPS/GLONASS) receiver for your location-based applications.